Cast Metal Letter Mounting Options
 |
Flush Mount – FMStuds are set in adhesive cement. There is no space between the letter and the wall surface. |
 |
Projected Jam Mount – PJMStuds are set in adhesive cement. Stainless steel jam nuts are inserted between the letter and the wall surface. |
 |
Projected Spacer Mount – PSMStuds are set in adhesive cement. Pre-cut spacers are inserted between the letter and the mounting surface. |
 |
Wall Mount – WMWhere you have access to the rear of the wall, washers and nuts are used on both sides. |
 |
Bottom Mount – BMLetters are drilled and tapped from the bottom for placement on aluminum bar for aluminum letters and stainless steel bar for bronze letters. Rounded letters will be flattened to receive studs. Large letters will require tie-backs. 3/8" and thicker letters only. Ships unassembled. Extra charge will apply. Maximum piece is 8'. Bar included. |
 |
Rail Mount – RMLetters are drilled and tapped for placement on two rails. Aluminum rails on aluminum letters and stainless steel rails on bronze letters. Maximum length is 8' per individual rail section. Available on letters 4" to 24". Ships unassembled. Extra charge will apply. Maximum piece is 8'. Rail included. |
Mounting Patterns:Installation templates are available at $2.50 NET per letter. |
|